Skip to content
Fitment · Can-Am

Defender HD11
wheels & tires.

Bolt pattern, studs and the 15-inch Packard wheel and tire sizes for the 2026–2027 Can-Am Defender HD11.

4x136/137Bolt pattern
M12x1.5Stud thread
2026–2027Model years covered

What fits

The numbers for your Defender HD11.

Bolt pattern4x136/137

Can-Am and Honda call this 4x136 or 4x137 — same wheel. Check the stud thread: X3/Talon are M12x1.5, Defender/Commander/Sport/Trail are M10x1.25.

Stud threadM12x1.5

Lug nuts must match the pitch. The wrong one starts on the stud, then binds.

CentringLug-centric

Conical seats centre the wheel on the studs.

Check it yourself

Measure before you order.

4x136/137 · 4 studs on a 136 mm circle
Measure across the diagonal.

Center of one stud to the center of the stud opposite: 136 mm. Neighbouring studs on a 4x156 hub sit about 110 mm apart, which is how 4x156 machines get ordered as 4x110.

Match the thread, not just the pattern.

M12x1.5 here. The wrong pitch starts on the stud and then binds.

Torque to the book.

Use the lug nut torque figure in your owner’s manual.

Taller tires cost acceleration.

Two inches over stock on a belt-driven car usually wants a clutch kit; sand paddles add rotating mass on top.

What Packard builds for it

6 forged styles in 4x136/137.

15x7 fronts and 15x11 rears, forged centers with beadlock or standard-lip barrels. The machine decides the pattern; you decide the rest.

All 4x136/137 wheels →Wheels filtered to your Defender HD11 →

Tires and parts

Finish the set.

Sand tires

Packard sand tires are built for 15-inch wheels. Steers up front, paddles in the rear.

All sand tires →

Same wheels fit

Machines that share 4x136/137.

Same pattern, so the same Packard wheel. The stud thread can still differ, so check it on each page.

Questions

Defender HD11 fitment questions.

What bolt pattern does the Can-Am Defender HD11 use?

The 2026–2027 Can-Am Defender HD11 uses a 4x136/137 bolt pattern. Can-Am and Honda call this 4x136 or 4x137 — same wheel. Check the stud thread: X3/Talon are M12x1.5, Defender/Commander/Sport/Trail are M10x1.25.

What lug nut thread does the Can-Am Defender HD11 use?

M12x1.5 studs. Use lug nuts with that pitch. A nut with the wrong pitch starts on the stud and then binds.

Is the Can-Am Defender HD11 hub-centric or lug-centric?

Lug-centric. Conical lug seats centre the wheel on the studs.

What size Packard wheels and tires fit the Can-Am Defender HD11?

Packard builds 15x7 fronts and 15x11 rears for it.

What other machines share wheels with the Can-Am Defender HD11?

The same 4x136/137 pattern is on the Can-Am Maverick X3, Can-Am Maverick Sport / Trail, Can-Am Maverick 1000R, Can-Am Commander, Can-Am Defender, Honda Talon 1000, Honda Pioneer 1000, Kawasaki Teryx / Teryx4. Check the stud thread before you swap lug nuts between them.